RGB LED Decking Light, 30mm, IP67, 12V, 0.3w, Colour Changing, Single Light

Add to a set or replace a light

This is a single 30mm RGB decking light. Use it to add lights to an existing run, replace one that's been damaged, or try the look before you buy a full set. It is 30mm across and 26mm high, with a stainless steel finish that suits timber and composite decking and blends in during the day.

Full RGB colour

The light shines in full RGB colour, from soft blues and purples to bright reds and greens, set from your RGB controller. A wide 110° beam spreads the colour across the boards without harsh glare. It is not dimmable.

Driver and controller needed

The light runs on 12V DC, so it needs a 12V LED driver and an RGB controller (V1 or V2) to work. They are not included. If you're starting from scratch, the packs of 6 and 10 come with a driver, controller and remote.

Low power, long life

The light uses just 0.3w, so a whole deck of them draws very little. Average life is 30,000 hours.

Sealed to IP67

It is sealed against dust and heavy rain, so it can stay in decking, steps and paths through every season. It also works as a kitchen plinth light.

Fitting

Drill a 22mm hole and push the light in. It has a 1m cable, 0.5m on each side, and daisy-chains with the other lights, and 1m extension leads are available separately if you need more cable. Use a qualified electrician for any mains connection to the driver.

Specifications

• In the box: 1 RGB decking light
• Power: 0.3w
• Colour: RGB, colour changing
• Beam angle: 110°
• Voltage: 12V DC
• Driver and controller: needed, not included
• IP rating: IP67
• Finish: stainless steel
• Diameter: 30mm
• Height: 26mm
• Cut-out: 22mm
• Cable: 1m (0.5m each side)
• Dimmable: no
• Average life: 30,000 hours