Wireless Kinetic Light Switch, 2 Gang, No Battery, No Wiring, IP65, 433MHz RF, White

Two lighting zones from one switch

This 2 gang wireless kinetic switch controls two separate lighting circuits from one place, such as room lights and outdoor lights, or main lights and feature lighting. It goes on the wall, or another convenient surface, with no cable to run and no battery to change. It measures 85 x 85 x 10mm and weighs 72g.

Powered by the press

Each press of a button makes enough energy to send a 433MHz RF signal to a compatible receiver on the lighting circuit. Range is up to 80m outdoors and 25m indoors. There is nothing to charge and nothing to replace.

Fit it where you need it

With no wiring at the switch there are no walls to chase and no floorboards to lift. Put it by an entrance, next to furniture, in an extension or in a garage, workshop or garden area where running cable would be awkward.

Multi-way switching

Add more compatible switches to control the same lights from several places, such as stairs, corridors, large rooms and outdoor areas, with no rewiring. You can add or move switch points later. The white finish blends into modern interiors.

Indoor and outdoor

The switch is IP65, protected against dust and water jets, and works from -20°C to 60°C, so it can go outside as well as in.

Built to last

The push-button mechanism is rated for more than 200,000 presses and the switch has a rated life of 100,000 hours.

Specifications

• Type: wireless kinetic push-button switch
• Gangs: 2
• Power: self-powered by the press, no battery
• Radio: 433MHz RF
• Range: up to 80m outdoors, 25m indoors
• IP rating: IP65
• Working temperature: -20°C to 60°C
• Rated presses: over 200,000
• Rated life: 100,000 hours
• Size: 85 x 85 x 10mm
• Weight: 72g
• Finish: white
• Needs: a compatible 433MHz kinetic switch receiver