4 Channel DMX512 and RDM LED Decoder, RJ45, Constant Voltage, 12-48V DC

DMX control for LED strip

This 4 channel decoder takes a DMX512 signal from a lighting console and drives constant voltage RGB or RGBW LED strip. It also supports RDM (Remote Device Management), which adds two-way communication so you can change the DMX start address or adjust settings remotely.

RJ45 in and out

Dedicated RJ45 input and output ports carry the DMX signal over standard network cable with plug-in connections, so installs are quicker and tidier. Daisy-chain several decoders on one DMX line. With more than 32 decoders on a line, add a signal amplifier, and fit a terminal resistor at the end of the line for a stable signal.

Set up on the unit

A digital display and buttons let you set the DMX start address on the decoder itself. It uses four DMX addresses, with 1, 2 or 4 channel output modes to suit the fittings.

Output

The decoder runs on 12-48V DC. At 12V and 24V each channel gives up to 8A; at 36V and 48V each gives up to 6A, for up to 1152w in total at 48V. Use it only with constant voltage LED products and a suitable constant voltage power supply, never with constant current fittings.

Smooth, flicker-free dimming

Choose a PWM frequency from 250Hz to 32kHz; higher settings cut visible flicker for cameras, shops, showrooms and exhibitions. 8-bit or 16-bit dimming gives 256 or 65,536 levels for smoother fades, with logarithmic or linear dimming curves.

Self-test and protection

If the DMX signal is lost, a self-test function starts, with five modes (L-1 to L-5) for commissioning and fault-finding. Overheat, overload, short-circuit and reverse-polarity protection are built in, with automatic recovery. The iron case has a built-in heat sink.

Where to fit it

The case is 175 x 46 x 32mm, so it fits in control cabinets and equipment enclosures. It is rated IP20 for dry indoor locations and works from -30°C to 55°C.

Specifications

• Type: 4 channel DMX512 and RDM decoder, constant voltage
• DMX ports: RJ45 in and out
• Input: 12-48V DC
• Output: 4 channels, 12-48V DC
• Output current: 8A per channel at 12-24V, 6A per channel at 36-48V
• Maximum output: 1152w at 48V
• DMX addresses: 4, with 1, 2 or 4 channel modes
• PWM frequency: 250Hz to 32kHz
• Dimming: 8-bit or 16-bit, logarithmic or linear curve
• Self-test: 5 modes
• Protection: overheat, overload, short-circuit, reverse polarity
• Case: iron, black, 175 x 46 x 32mm
• Working temperature: -30°C to 55°C
• IP rating: IP20