200W IP67 Waterproof LED Driver, 24V DC Constant Voltage, 220-240V Input

200W for large 24V installations

This LED driver supplies up to 200W at 24V DC, enough to run several lighting sections from one supply. It suits long LED strip runs, architectural and feature lighting, signs and garden lighting, and means fewer drivers and fewer connections to look after.

Constant 24V output

The driver turns 220-240V AC mains into a steady 24V DC constant voltage output. Use it with lights rated at 24V, such as strip, plinth lights and cabinet lights; it is not suitable for 12V fittings. A 24V system also loses less voltage over long cable runs than 12V, so the driver can sit further from the lights.

Sealed to IP67

The housing is fully sealed against dust and can cope with temporary immersion in water, so the driver can be fitted outdoors, in damp areas or anywhere it may be exposed to rain and splashes.

Built-in protection

Overload protection stops the driver running beyond its rated power, short circuit protection cuts the output if there's a wiring fault, and over-voltage protection keeps voltage spikes away from the LEDs. The power factor is above 0.95.

Sizing and fitting

Add up the wattage of everything you plan to connect and keep the total below 200W. The driver measures 155.6 x 47.6 x 32.5mm and has about 250mm of cable on each side. It is not dimmable. Have a qualified electrician make the mains connection.

Specifications

• Output: 200W, 24V DC constant voltage
• Input: 220-240V AC
• IP rating: IP67
• Protection: overload, short circuit, over-voltage
• Power factor: above 0.95
• Size: 155.6 x 47.6 x 32.5mm
• Cables: about 250mm each side
• Dimmable: no