Wireless Kinetic Light Switch, 1 Gang, No Battery, No Wiring, IP65, 433MHz RF, White

A light switch with no wiring and no batteries

This wireless kinetic switch goes on the wall wherever you want a switch, with no cable to run and no battery to change. It suits extensions, sheds, garages, garden rooms and renovations where running cable is a nuisance. It is 85 x 85 x 10mm and weighs 72g, so it sits neatly on the wall.

Powered by the press

Each press of the button makes enough energy to send a 433MHz RF signal to a compatible receiver on the lighting circuit. Range is up to 80m outdoors and 25m indoors. There is nothing to charge and nothing to replace.

Fit it in minutes

Mount the switch by a door, next to a bed, in a workshop or at the far end of a garden building. With no wiring at the switch there are no holes to drill through walls and no floorboards to lift, and you can move it later if your layout changes.

Indoor and outdoor

The switch is IP65, protected against dust and water jets, so it can go in bathrooms, workshops, outbuildings, by gates and in the garden. It works from -20°C to 60°C.

2-way and multi-way switching

Control the same lights from several places without running cable between switches. Use two switches for stairs, hallways and large rooms, or more for garages, offices and outdoor areas. One receiver pairs with up to 10 switches.

Built to last

The push-button mechanism is rated for more than 200,000 presses and the switch has a rated life of 100,000 hours.

Specifications

• Type: wireless kinetic push-button switch
• Gangs: 1
• Power: self-powered by the press, no battery
• Radio: 433MHz RF
• Range: up to 80m outdoors, 25m indoors
• Switches per receiver: up to 10
• IP rating: IP65
• Working temperature: -20°C to 60°C
• Rated presses: over 200,000
• Rated life: 100,000 hours
• Size: 85 x 85 x 10mm
• Weight: 72g
• Finish: white
• Needs: a compatible 433MHz kinetic switch receiver